Product name:
Ceramic tile adhesive (super strong type)
Product specifications:
Ceramic tile adhesive (super strong type) package, square paper bag.
1. Characteristics
This product is a new type of high-strength ceramic tile adhesive, suitable for pasting all types of ceramic tiles.
There is no need to soak bricks into wet walls during construction, which can significantly improve work efficiency and is convenient and fast.
It has strong adhesion and saves materials. Compared with the traditional cement slurry pasting method, it is safer and stronger. It can also reduce construction waste and wall weight.
, has good impermeability and anti-aging properties.
, small shrinkage, no cracking, and can be used in cold and humid environments.
2. Scope of application
Cement foam, brick walls, smooth cement surfaces with ceramic tiles and stone.
Paste ceramic tiles and stones on base surfaces with low water absorption and lightweight boards (such as Etter boards, pine boards, gypsum boards, etc.).
3. Base Surface Treatment
The surface of the base material should be strong and flat, dry and clean, free of grease, wax dye, concrete curing agent, release agent and other loose matter.
4. How to use
Mix the strong tile adhesive with clean water (approximately 1 kg of powder to 1 kg of water) and stir into a uniform, powder-free paste. Wait until the glue has settled. Let it sit for ten minutes and then stir for better results.
Use a toothed scraper to spread the glue on the work surface to distribute it evenly. Adjust the angle between the scraper and the work surface to control the thickness of the glue. Apply about square meters each time, and then place the tiles or Just knead the stone and press it on.
If the tile or stone has a deep groove on the back, in addition to grouting the working surface, grout should also be applied on the back of the tile or stone.
5. Normal dosage
The coverage area varies according to the specific conditions of the project
, use a х toothed scraper about .kg square meters
, use a х toothed scraper Approximately 1kg square meter
, using х toothed scraper is about 1kg square meter.
Note: Wall tiles use х or х toothed scrapers and floor tiles use х or х toothed scrapers.
6. Precautions
The verticality and flatness of the substrate must be determined before construction.
. Do not mix the dried glue with water before use.
. Check the glue layer on the back to ensure there is no hollowing.
Only one hour after the paving is completed, you can step in or fill the gaps.
7. Storage method
Store in a cool and dry place. Unopened products can be stored for one year.
Ceramic tile adhesive 609 (super strong type)